Parameter
snc/data_protection/max
Short text
Limit on the data protection of Secure Network Communications
Parameter Description
This parameter specifies the data transfer protection for connections that were initiated by the R/3 System, including cases where for the CPI-C or RFC destination used as the QOP (quality of protection), the use of the maximum is set in the SNC options (QoP=9). The parameter is not an upper limit for incoming or outgoing connections.
You should only change this parameter is if it absolutely necessary to do so.
Application Area
SNC
Parameter Unit
Integer value
Default Value
3 (privacy of data )
Who is permitted to make changes?
The customer
Operating System Restrictions
None
Database System Restrictions
None
Are other parameters affected or dependent?
snc/enable – Activate the SNC module (Secure Network Communications)
snc/data_protection/min – Lowest requirement for data transfer protection
snc/data_protection/use – default level for data transfer protection
Values allowed
>= snc/data_protection/use
1 (Secure authentication only)
2 (Data integrity protection)
3 (Data privacy protection)
