The lanadmin program administers and tests the Local Area Network (LAN). For each interface card, it allows you to:
• Display and change the station address.
• Display and change the 802.5 Source Routing options (RIF).
• Display and change the maximum transmission unit (MTU).
• Display and change the speed setting.
• Clear the network statistics registers to zero.
• Display the interface statistics.
• Display the interface usage information.
• Reset the interface card, thus executing its self-test.
• Configure VLANs on the cards that support VLAN.
lanadmin reads commands from standard input, writes prompts and error messages to standard error, and writes status information to standard output. lanadmin operates in two modes: Menu Mode and Immediate Mode.
1. Execute command lanadmin
# lanadmin
LOCAL AREA NETWORK ONLINE ADMINISTRATION, Version 1.0
Wed, Oct 19,2011 19:56:52
Copyright 1994 Hewlett Packard Company.
All rights are reserved.
Test Selection mode.
lan = LAN Interface Administration
menu = Display this menu
quit = Terminate the Administration
terse = Do not display command menu
verbose = Display command menu
Enter command:
2. Type menu for main menu.
Test Selection mode.
lan = LAN Interface Administration
menu = Display this menu
quit = Terminate the Administration
terse = Do not display command menu
verbose = Display command menu
